Nehalem og Ram OC måske et problem

  • Har lige læst denne newz


    http://www.techpowerup.com/711…nd_Limits_on_Nehalem.html


    Quote


    Intel's upcoming Nehalem architecture brings in a host of changes. One of the most important of them is that the processors now carry memory controllers. From what is known so far, the upcoming Nehalem processors come with official support for DDR3 800 MHz and DDR3 1066 MHz though talk is that it just could slip in DDR3 1333 MHz support on an official scale. Here's a complication: Some of the computer enthusiasts with plans of retaining their current DDR3 1800/2000/beyond may have severe problems running the memory at their rated frequencies on a Nehalem chip. They might not work on their rated frequencies at all.


    The reason behind this is that Nehalem has processor and memory voltages synchronized. Fresh studies suggest that a voltage of 2.0 V can fry a Nehalem processor. It was earlier noted that this voltage limit was 1.60 V to 1.70 V. It would need extreme caution for you to set the core to run at even 1.8 V since at that voltage the processor could start degrading and finally cease to work. The conclusion is that the Nehalem platform, with its synchronized CPU and memory voltages, will be limited by the DDR3 modules ability to reach high frequencies at lower voltages. This could have implications on the kind of memory kits that come out in the near future. Manufacturers could offer high-end kits that function well within 1.6 V with the supposedly high frequencies albeit loose timings, just to keep the memory and processor operating safely.


    Og i korte træk så køre volten på cpu og ram synkront på Intel kommende Nehalem, så sætter man volten op på ramme for at OC eller bare køre sine ram med rated volt så vil volten på cpu'en også stige så hvis man f.eks. køre med Crucial's PC16000 ram og køre rated volt så bliver der også sendt 1.9volt til cpu'en som den helt sikkert ikke har godt af.

  • mon ikke vi hurtigt får at se nogle modificerede bios versioner, der tillader at de ikke kører synkront...amd havde da ingen problemer med oc mda de introducerede deres intgrerede memorycontroller i socket 939.....

    Asrock x570 Taichi, Asrock 5700XT Challenger 8GB@AMD ryzen 7 2700X 3,7mhz, 4*16Gb DDR4g. G-skill TridentZ neo 3600, Seasonic 700W PSU, Kingston SSD M.2 1TB Harddrive.

  • Quote

    Oprindeligt indlæg af Cyclups
    Uheldigvis skriver Gibbo ikke hvilken volt han bruger, cpu-z skriver 1.435v men spørgsmålet er om den kan læse den rigtigt, man må jo bare håbe at dette ikke er et problem.


    Gibbo skriver faktisk det her Cyclups:


    Whats very impressive is the CPU does 3.60GHz stable at just 1.275v, which means even on the stock cooler temps remain under 65-70c when running prime....