Jeg lavede for nylig en større udskiftning fra et gammel Asrock P45 mobo + Q9650
til I7 serien. Mit nye system ser således ud :
Asus rampage III extreme
Intel I7 970
3 x 2 gbKingston HyperX 2000 mhz
Scythe Mugen 2 rev. cpu køler
Silverstone strider plus 1000 W psu
Jeg har nu efterhånden fået det hele op og køre og er begyndt at tænke på lidt OC, men må indrømme at bios'en samt funktionerne ved I7 serien er noget anderledes end min gamle Q9650 som jeg også havde Oc'et.
Men efter megen læsning på nettet har jeg ny stykket følgende bios sammen :
Target CPU Frequency 4000 MHz
Target DRAM Frequency ??MHz
LN2 Mode [Disabled]***
QPI Loadline Calibration [Enabled]***
Sync Mode []
AI Overclock Tuner [Manual]
OC From CPU level Up [Auto]
CPU Ratio Setting [23]
CPU Turbo Power Limit [Disabled]
>CPU Configuration----------------------------
CPU Ratio Setting [23]
C1E Support [Disabled]
Hardware Prefetcher [Disabled]
Adjacent Cache Line Prefetcher [Disabled]
Intel(R) Virtualiyation Tech [Disabled]
CPU TM Function [Disabled]
Execute Disable Bit [Disabled]
Intel(R) HT Technology [Enabled]
Active Processor Cores [1]
A20M [Disabled]
Intel(R) SpeedStep(TM) Tech [Disabled]
Intel(R) C-STATE Tech [??]
C State package limit setting [??]
----------------------------------------------
BCLK Frequency [174]
PCIE Frequency [100]
DRAM Frequency [?] Laveste??
UCLK Frequency [?] Laveste??
QPI Link Data Rate [?] Laveste?
Memory Configuration Protect [Enabled]
>DRAM Timing Control--------------------------
CAS# Latency []
RAS# to CAS# Delay []
RAS# PRE Time []
RAS# ACT Time []
RAS# to RAS# Delay []
REF Cycle Time []
WRITE Recovery Time []
READ to PRE Time []
FOUR ACT WIN Time []
Back-To-BackCAS# Delay []
Timing Mode []
Round Trip Latency on CHA []
Round Trip Latency on CHB []
Round Trip Latency on CHC []
WRITE To READ Delay(DD) []
WRITE To READ Delay(DR) []
WRITE To READ Delay(SR) []
READ To WRITE Delay(DD) []
READ To WRITE Delay(DR) []
READ To WRITE Delay(SR) []
READ To READ Delay(DD) []
READ To READ Delay(DR) []
READ To READ Delay(SR) []
WRITE To WRITE Delay(DD) []
WRITE To WRITE Delay(DR) []
WRITE To WRITE Delay(SR) []
----------------------------------------------
CPU Differential Amplitude [800 MV]
CPU Clock Skew [auto]
IOH Clock Skew [auto]
------------ Extreme Engine Digi+ ------------
Digi+ PWR Mode [T-power]
PWR Volt. Control [Auto]
Load-Line Calibration [Enabled 100%]
CPU Voltege OCP [Enabled]
CPU PWM Frequency [1000Hz]
Extreme OV [Enabled]
Extreme OC [Auto]
CPU Voltage [1,25]
CPU PLL Voltage [1,55] Er det nok?
QPI/DRAM Core Voltage [1,38]
DRAM Bus Voltage [1,6]
>DRAM REF Voltages----------------------------
DRAM DATA REF Voltage on CHA []
DRAM CTRL REF Voltage on CHA []
DRAM DATA REF Voltage on CHB []
DRAM CTRL REF Voltage on CHB []
DRAM DATA REF Voltage on CHC []
DRAM CTRL REF Voltage on CHC []
----------------------------------------------
IOH Voltage [1,17]
IOH PCIE Voltage [1,51]
ICH Voltage [1,15]
ICH PCIE Voltage [1,51]
---------- Spread Spectrum Control -----------
CPU Spread Spectrum [Disabled]
DRAM Spread Spectrum [Disabled]
Ville det være et fornuftigt moderat oc på luft eller er der nogle indstillinger som skal ændres? Og hvad skal jeg sigte efter med min ram?